This document gives the safety requirements and measures for manually loaded and unloaded 
stationary vertical panel sawing machines, hereinafter referred to as “machines”.
NOTE 1 In manual loading, the operator puts the work-piece directly onto the work-piece support, with no intermediate loading device to receive and transfer the work-piece from the operator to the cutting position. In manual unloading, the operator removes the work-piece directly from the work-piece support, with no intermediate unloading device to transfer the work-piece from the cutting position to the operator.
It deals with all significant hazards, hazardous situations and events as listed in Clause 4 relevant to machines, when operated, adjusted and maintained as intended and under the conditions foreseen by the manufacturer including reasonably foreseeable misuse. Also, transport, assembly, dismantling, disabling and scrapping phases are taken into account.
NOTE 2 For relevant but not significant hazards, e.g. sharp edges of the machine frame, see ISO 12100:2010.
It is also applicable to machines fitted with one or more of the following devices/additional working units, whose hazards have been dealt with:
— an integrated feed device;
— a device for scoring;
— an angle cutting device;
— a middle support device;
— programmable end stops for parallel vertical cuts;
— a device for grooving with a width of at most 20 mm in one pass by using a milling tool; and
— a panel pusher.st edition 2018-02 Woodworking machines — Safety — Part 4: Vertical panel circular sawing machines Machines à bois — Sécurité — Partie 4: Scies circulaires à panneaux verticales Reference number ISO 19085-4:2018(E) ？ ISO 2018 ISO 19085-4:2018(E) COPYRIGHT PROTECTED DOCUMENT ？ ISO 2018 All rights reserved. Unless otherwise specified, or required in the